Force value in test bench
Posted: 19 Apr 2021, 08:45
[Question]We cannot see any logic design to control the test pattern in the “force” syntax, do we need adding design to modify these force codes by ourselves?
[Answer] Because some customers use the testcase provided by START but don’t correctly assign initial data to don’t touch ports. And it causes memory could not work normally. So, START use force to assign initial value for these don’t ports.
If customers can assign initial value for these don’t port in their design, then customer can remove these force codes.
[Answer] Because some customers use the testcase provided by START but don’t correctly assign initial data to don’t touch ports. And it causes memory could not work normally. So, START use force to assign initial value for these don’t ports.
If customers can assign initial value for these don’t port in their design, then customer can remove these force codes.