[Answer] Yes, if user want to execute BII flow to integrate all controller, user should turn on “integrator_mode”. In BII flow, START tool will integrate these input/output pins, like red block in following picture, into INTEG module.
Integrator_mode enable
Integrator_mode enable
[Question] If I want to run BII flow, should I turn on “integrator_mode” in BFL file?
[Answer] Yes, if user want to execute BII flow to integrate all controller, user should turn on “integrator_mode”. In BII flow, START tool will integrate these input/output pins, like red block in following picture, into INTEG module.
[Answer] Yes, if user want to execute BII flow to integrate all controller, user should turn on “integrator_mode”. In BII flow, START tool will integrate these input/output pins, like red block in following picture, into INTEG module.